Installing a toilet is a lot easier than you might think and just about anyone can do it. Whether your old toilet is past its usefulness or you want to add a new one to match your décor, the process is pretty easy and should only take a few hours. Before you get started, you’re going to need a few basic tools. They include:
- plumber’s putty
- pipe wrenches to fit your pipes
- screwdrivers
- regular wrenches
- putty knife
- silicone
- an old rag
Let’s get started!
IMPORTANT: Not all new toilets come with the necessary parts. BEFORE you get started make sure that your new toilet has everything you need for installation. You can ask the store clerks where you got the toilet for more information.
First, you’re going to need to remove your old toilet. Turn the shutoff valve (it’s located right near the toilet) to the off position. Flush the toilet a few times and then mop up any excess water. Now, disconnect the water supply tube from the toilet. You may have some additional water here, but it shouldn’t be much. If necessary, place a sponge underneath it before you loosen the bolts. You may need to use your wrench if the area is corroded.
Once this is complete, you will then need to loosen the bolts on the toilet. Remove the little caps on either side of the base and undo these bolts. Again, you may need to use that wrench or a pair of pliers to get it going. In severe cases, you may need to hacksaw them off or use WD40 to loosen the bolts.
Now, you’re going to have to separate the old tank from the old bowl. Get your screwdriver and use it to hold the end of the bolt on the inside of the tank. Use your wrench to move the nut on the other side. Slowly remove the bolt and then rock the bowl from side to side. You’re going to want to do this pretty gently so you don’t damage the bowl. Once it’s loose, lift it out and place it in a safe place. Move the tank as well.
You’ll most likely notice a big hole in the floor and there may be a nasty smell coming out of it. This is the line to the sewer. Grab that old rag and stuff it into the hole (not too far or you’ll end up losing the rag and you’ll have to call a plumber to get it back.) You need to block this hole immediately or you will have dangerous sewer gases floating around your home and trust us, no one wants that.
Use that putty knife around this hole to scrape off any excess wax from the old gasket. Upend the new toilet and take your new gasket. Place it around the hole on the toilet and caulk it. Remove the rag from the sewer line and place the new toilet over it. Gently rock the new bowl into place until the seal is firm. Add on the new tank, attach the fittings inside and then bolt the new toilet down to the floor. Don’t overtighten those bolts or you will crack the bowl. Use your plumbers putty to attach the caps over the bolts. Reattach the water line and give her a flush!
Photo Credits: 1
If you liked this article, vote for it on del.icio.us and stumbleupon.Have you always wanted to tackle home improvement projects on your own but you weren't sure where to start? The Do-It-Yourselfer's Ultimate Guide to Home Improvement has all the answers you need! Click here to download the 30 page the 100% FREE eBook "The DIY Handbook."
If you prefer a real book, this book can be bought as a paperback from LuLu.com for $10.93.
Categories:
Bathroom, Handy Man, Install, Replace, Toilet
Tags:
basic tools, bolts, excess water, hacksaw, hole in the floor, installing a toilet, nasty smell, old rag, old tank, pliers, plumber, putty knife, safe place, screwdriver, shutoff valve, silicone, sponge, store clerks, supply tube, water supply
Related Articles Related Stores
0 comments ↓
There are no comments yet...Kick things off by filling out the form below.
Leave a Comment